Firmware Download

Download the old version

Download Type Firmware
Model name IC-7610
Version Version 1.42
Update Jun.18.2024
Major changes

Changes from Version 1.41

  • Fixed a bug that caused an error in communication with the HDSDR (free SDR software: https://www.hdsdr.de/) using the [USB 2] port for the I/Q data output.
Note

To update the firmware

  • To update from firmware version 1.05 or older to 1.11, the IC-7610 needs to have firmware version 1.06 installed.
  • Thoroughly read Section 6, SD CARD/USB FLASH DRIVE, in the BASIC MANUAL and the Section 13, UPDATING THE FIRMWARE, in the ADVANCED MANUAL, and follow the instructions displayed on the IC-7610 LCD screen.
  • BE SURE to make a backup copy of your data settings to an SD card/USB flash drive before updating the firmware.
  • The firmware will be updated to the following versions.
    • Main CPU: 1.42
    • Sub CPU: 1.06
    • Front CPU:1.01
    • FPGA: 1.12
File Size 8.03MB
File Type zip
Manual manual download page

Regarding this Download Service.

When using this download service, the implementation, use and/or results of use are the sole responsibility of you using this download service and the equipment. You shall comply with applicable laws and regulatory requirements in the use of this download service and in the operation of the equipment.

Firmware is important data for the basic system control of your equipment. An interruption during downloading or a malfunction may cause a failure in the data re-writing, and your equipment may stop functioning normally. If such a failure of the firmware re-writing results in your equipment not functioning normally, Icom Inc. and its affiliates expressly denies and is free from any and all responsibility arising from the result of damage from such an event.

You agree not to hold Icom Inc. and its affiliates responsible for any damage to your equipment operation or loss of data, or unauthorized use of the equipment, whether intentional or not, as a result of use this download service.